 |
 |
| Wear Protection Products: |
Contact Us: Product Sales Applications Product enquiries: Wearcon (PTY) Ltd |
Description
WEARCOAT “FC” is a 100% solids modified epoxy resin system containing sapphire hard alumina ceramic beads to withstand severe cavitation, tough abrasion and moderate impact.
Application
WEARCOAT “FC” is applied to the prepared surface with a trowel or by hand at the required thickness, from 3mm upwards, depending upon the application.
Surface preparation
A properly prepared surface is important to the end result and lasting durability of WEARCOAT “FC”. Steel surfaces should be dry grit blasted to SA 2.5 with blast profile between 50-70 microns to leave the surface free of oil and grease contamination. In cold conditions it is recommended to warm the substrate to 30-35°C.
Specifications
| Compressive strength | 95.5 Mpa |
| Flexural Strength | 52 Mpa |
| Impact strength | 25 Jm |
| Specific gravity | 1.97 |
| Working time | 20 min |
| Gel time | 35 min |
| Curing time | 1 hour |
| Heat deflection | 250 – 300°C |
| Acid resistance at room temp | |
| Caustic soda | 50% |
| Sulphuric Acid | 60% |
| Phosphoric Acid | 10% |
| Sodium hydroxide | 50% |
| Hydrochloric Acid | 20% |
Theoretical coverage
1 m2 at 4 mm thickness per 12 kg kit
Typical application
Lining of pipe bends, slurry lines, pump casing, cyclones, conveyor pulleys, chutes, hoppers, launders and feeder boxes etc.
Kit Size: 12 Kg
 |
WEARCON (PTY) LTD - Wear Linings |
 |