| Wear Protection Products: |
|
|
|
|
|
|
|
|
|
|
|
|
Wearcoat "AD" Abrasion Protection – Wearing Compound
Description
WEARCOAT “AD” is a 100% solids modified epoxy resin system formulated to withstand severe cavitation, tough abrasion and moderate impact.

Application
WEARCOAT “AD” is applied to the prepared surface with a trowel or by hand at the required thickness, from 3mm upwards, depending upon the application.
Surface preparation
A properly prepared surface is important to the end result and lasting durability of WEARCOAT “AD”. Steel surfaces should be dry grit blasted to SA 2.5 with blast profile between 50-70 microns to leave the surface free of oil and grease contamination. In cold conditions it is recommended to warm the substrate to 30-35°C.

Specifications
| Compressive strength |
115 Mpa |
| Flexural Strength |
52 Mpa |
| Impact strength |
25 Jm |
| Specific gravity |
1.97 |
| Working time |
30 min at 25°C |
| Gel time |
45 min at 25°C |
| Curing time |
4 Hrs at 25°C |
| Heat deflection |
250 – 300°C |
| |
|
| Acid resistance at room temp |
| Caustic soda |
50% |
| Sulphuric Acid |
60% |
| Phosphoric Acid |
10% |
| Sodium hydroxide |
50% |
| Hydrochloric Acid |
20% |
Theoretical coverage
1m2 at 4mm thickness per 12kg kit
Typical application
Lining of pipe bends, slurry lines, pump casing, cyclones, conveyor pulleys, chutes, hoppers, launders and feeder boxes etc….
Kit Size: 12Kg
 |
WEARCON (PTY) LTD - Wear Linings
Abrasion Protection, Wear Resistant Linings, Epoxy Resin, Acid-Proof Epoxy Resin Systems, Steel Putty, Metal Repair Putty, Epoxy Grout, Pipe Linings, Crusher Backing Material
|
 |
|